DTF Pressing Instructions

DTF PRESSING INSTRUCTIONS

1. Use a lint roller to remove any lint on the t-shirt’s press area.

2. Pre-press the garment for 5-7 seconds to remove moisture.

3. Place the design on the garment and press according to “Press Settings” below. You may need to do a few test prints to find the optimal press settings for your specific equipment and environment.

4. COLD PEEL FILM: WAIT UNTIL THE TRANSFER IS COOL TO THE TOUCH, then peel.

5. Post-press the garment for 10 seconds.

*NOTE: When pressing, using a Teflon sheet between the press and the design produces the best results

DTF PRESS SETTINGS

1. Actual press settings may differ due to equipment used and environmental conditions such as room temperature and humidity. 

2. Press at medium to high pressure.

  •   FOR COLD PEEL:

     a. 100% Cotton:  start at 325 for 15 seconds and adjust as necessary

     b. Polyester Blend:  270-290F for 15 seconds and adjust as necessary 

     c. Peel when transfer is cool to touch.

 

DTF Care Instructions

Storage:

Transfers should be stored in a dry place, ideally in a Ziploc bag

Garment Care:

Wash garment with warm water. 

Tumble dry at “delicate” setting.

Do not iron design directly. If necessary, iron at low setting on the inner side of the garment